Manitowoc Ice Q-SERIES Q-0600 Manual do Utilizador descarregar pdf

Q-0600 Compressor Replacement

Installation Instructions

NOTE: THIS REPLACEMENT IS ONLY FOR THE Q-SERIES MACHINES. NO CHANGES WITH

START/RUN COMPONENTS ARE NEEDED.

1. Disconnect power to the ice machine at the electrical

disconnect (moving the toggle switch to the off

position will not disconnect line voltage).

2. Remove panels (top, front, left and right sides).

3. Recover refrigerant from ice machine.

4. Remove right side corner post (when facing the front

of the machine) and back panel.

5. Remove wiring from compressor terminals.

6. Cut tubing (suction, discharge, and process lines) at

the compressor ports.

7. Remove compressor from machine. Make sure to

crimp and braze shut ports to compressor.

8. Remove extra section of suction service valve

process tube from the ice machine at swedge joint.

Repeat this procedure with discharge line. Remove

up to T section.

9. Insert new compressor into the machine as shown.

Manitowoc Ice, Inc.

2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8006173

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Sheet 1 of 3

Web Site -

www.manitowocice.com 06/25/01

Suction

Process

Discharge

Swedge Joint

T Section

1 2 3

Q-0600 Compressor Replacement Installation Instructions NOTE: THIS REPLACEMENT IS ONLY

10. Fit tubing provided into the proper place, as shown. Make sure that the discharge line ends up on the inside of the suction line. Cut ice machine

21. Reinstall all other panels. 22. Reconnect power and test run ice machine.

Sem comentários

Manitowoc Ice Q-SERIES Q-0600 Manual do Utilizador